Filter Press Gear Pump - NL3000L

Filter Press Gear Pump – NL3000L

Compact by design, the energy efficient positive displacement NL Series? helical gears with tight tolerances reduce mechanical losses and internal slippage to maximize volumetric efficiency; enabling self-priming capabilities providing you an economical lead-free filter press pump solution

Request A Quote

SKU: NL3000L Category: Gear Pumps

Description

FEATURES

All pump components are lead free and corrosion resistant
Special helical gears for quiet operation
Stainless steel shafts & fasteners
Braided compression packing seals (with Teflon? dispersion) standard

DRIVE

Either direct drive with flexible coupling or pulley drive can be used. Make sure both flexible coupling halves are properly aligned. When using a pulley, do not over tighten the belt. Also, to absorb belt side thrust at higher pressures and larger size pumps, an external ball bearing support is recommended – consult factory.

LIQUIDS & TEMPERATURES

Service life will be increased substantially if the liquid pumped is clean and has some degree of lubricity. These positive displacement pumps have tight tolerances. Fine abrasives like sand, silt, or powders in suspension will accelerate pump wear and reduce throughput. Liquids compatible with Lead Free Alloy and stainless steel can be pumped providing proper seal has been specified (see chemical compatibility or check factory). When possible, flush the pump after each usage. Temperature extremes are detrimental to service life and should be avoided. Basic metals of construction allow a temperature range of -40?F to 400?F. Some lip and mechanical seal elastomers have a limit of 212?F. (see engineering data or check factory). Allowing a liquid to freeze in the pump can cause damage.

SUCTION LIFT

Close tolerances and the positive pumping action make the rotary gear pump capable of lifting water on the suction side as high as 20 feet. Though gear pumps are self priming, a foot valve is recommended. If possible, wet the gears with liquid to be pumped for the first dry start. Liquid retained in the system and gear chambers serves to ?wet? the pump on subsequent starts.

BY-PASS AND ROTATION

The pump by-pass is not intended to be a metering or flow control device. Its main purpose is to function as a pressure relief when the desired set point is exceeded, overheating can occur within 5 -10 minutes if the discharge line is completely shut off for extended periods. Reversing rotation reverses the ?IN? and ?OUT? ports and the location of the by-pass ports have to be reversed.

The by-pass valve is factory set at 50 p.s.i. To increase the set point, turn the by-pass valve adjusting screw in a clockwise direction.